Opti-Cide 3 Disinfectant Cleaner / Sanitizer Liquid

MEDICAL/SURGICAL/HOSPITAL USE

2 MINUTE KILL TIME
Acinetobacter baumannii
Listeria monocytogenes
Avian Influenza A (H3N2) Reassortant Virus
Mycobacterium bovis, BCG (tuberculosis) (TB)
Escherichia coli with ESBL (E. coli)
Pseudomonas aeruginosa
Hepatitis B Virus (HBV)*
Rotavirus Strain WA
Hepatitis C Virus (HCV)*
Salmonella enterica
Herpes Simplex II Virus (HSV 2) G Strain
Serratia marcescens
Human Immunodeficiency Virus (HIV1)*
Staphylococcus aureus
Swine Influenza A Virus (H1N1)
Methicillin-Resistant Staphylococcus aureus (MRSA)
Influenza A Virus Strain A2/Hong Kong
Trichophyton mentagrophytes (ringworm)
Klebsiella pneumonia-Carbapenem resistant (KPC)
Vancomycin-Resistant Enterococcus faecium (VRE)

VETERINARY/PET CARE FACILITY USE

3 MINUTE KILL TIME
Bordetella bronchiseptica (kennel cough)
Feline Leukemia Virus
Bovine Viral Diarrhea Virus
Infectious Bovine Rhinotracheitis Virus
Duck Hepatitis B Virus
Murine Norovirus
Canine Distemper Virus
Streptococcus equi
Canine Para-Influenza Virus
Canine Parvovirus (5 minute contact time - wipes only)
Chlamydia psittaci (parrot fever)

It is a violation of Federal law to use this product in a manner inconsistent with its labeling. Apply this undiluted product
by sponge, rag, cloth, mop, spray or immersion to wet all surfaces thoroughly.

SOLUTION DIRECTIONS FOR USE

NON-FOOD CONTACT SURFACES

FOR SURFACE CLEANING
Prior to surface disinfection or sanitization**, pre-clean surfaces, making sure to remove all gross filth and heavy soil, by saturating surfaces with this product by spray, mop, rag, towel, paper towel, pour or immersion then wipe surface clean. Repeat, if necessary, until surfaces are visibly clean. Discard paper towels or launder cloth towels before reusing.

FOR SURFACE SANITIZATION
Apply this product to clean surfaces by sponge, cloth, mop, spray or immersion to wet all surfaces thoroughly. Allow to remain visibly wet for 10 seconds for non-food contact surfaces at room temperature, then wipe surfaces using a clean mop, paper or cloth towel, or rinse surface using potable water or wipe surface dry or allow to air dry. Discard or launder spent materials before reuse.

FOR SURFACE DISINFECTION
Apply this product to pre-cleaned surfaces by sponge, cloth, mop, spray or immersion to wet all surfaces thoroughly. Allow to remain wet for the appropriate time indicated for the purpose intended, then wipe dry using a mop, clean paper or cloth towel, or rinse surface using potable water and wipe surface dry or allow to air dry. Discard or launder spent materials before reuse. ** When indicated for Sanitization use (for non-food contact surfaces)

WIPES DIRECTIONS FOR USE

DISPENSING DIRECTIONS
To start feed, remove cover and discard seal. From the center of the wipe roll, pull up a wipe corner, twist it into a point
and thread it through the hole located on the container cover. Pull through about one inch. Replace cover. Pull out first wipe and tear off at an angle. Remaining wipes feed automatically, ready for the next use. When not in use, keep center cap closed to prevent evaporation.

CLEANING AND SANITIZING / DISINFECTION OF SURFACES
Use a fresh wipe to pre-clean surfaces of all gross filth and heavy soil. Repeat as necessary until surfaces are visibly clean. To effectively sanitize or disinfect the pre cleaned surfaces, use a fresh wipe or turn the wipe over to its clean side to thoroughly wet the surfaces and allow surfaces to remain wet for the appropriate time indicated for the purpose intended.